Navigate to Bridge Geometry > Support Lines in the tree view.
Navigation
Step 2: Create End Bent Support Line
Click the three-dots icon on the first cell of Bridge and select Bridge1.
Set the station to 0 ft for the first end bent location (Abut1).
Step 3: Create Pier and Abutment Support Lines
Create support lines for the remaining permanent structures:
Name
Station
Abut1
0 ft
Pier1
150 ft
Pier2
300 ft
Abut2
450 ft
Support Lines
Step 4: Add Temporary Support Lines
The permanent support lines are designated for End Bent and Pier Cap locations. Now add Temporary Support locations for sequential assembly of Girder Segments.
Temporary Supports
Enter the names and stations for all Temporary Supports as shown.
Step 5: Verify Skew and Offset
Confirm that support lines have no Skew Angles or Transverse Offsets for this example.
No Skew
Quick Tip: Transverse Offset Direction
Offset values use PGL (Profile Grade Line) as the reference point.
Offset Direction
Verification
After completing these steps, the support lines should appear as shown below.
